FAA Mandates Airbus AS365 and EC155 Rotor Nut Torque Checks
The Federal Aviation Administration has superseded an airworthiness directive to mandate expanded main rotor servo-control nut torque inspections across Airbus AS365 and EC155 helicopter fleets.
The Federal Aviation Administration (FAA) has published a final rule airworthiness directive superseding earlier safety mandates for multiple commercial models of Airbus Helicopters. The regulatory directive, designated as AD 2026-22-15 under Docket FAA-2026-4664, requires commercial operators and Part 145 repair stations to execute repetitive inspections of the tightening torque on nuts securing the upper ball bearing ends of main rotor servo-controls.
The airworthiness mandate formally supersedes FAA AD 2025-13-09 and applies to all Airbus Helicopters Model AS-365N2, AS 365 N3, EC 155B, EC155B1, SA-365N, and SA-365N1 rotorcraft certificated in any category. The comprehensive directive becomes legally effective on December 28, 2026, and establishes standardized technical criteria for detecting lost clamp load and preventing catastrophic flight control separation.
Root Cause Traced to Lock-Washer Paint
The federal directive was prompted by mandatory continuing airworthiness information issued by the European Union Aviation Safety Agency (EASA AD 2025-0239). Engineering investigations conducted by the airframe manufacturer revealed that loss of tightening torque between the upper ball bearing end and the main rotor servo-control assembly was directly caused by paint contamination on the mating surfaces of the lock-washer.
Under cyclic operational flight loads and dynamic vibration, paint layers trapped beneath the washer face undergo compression, degradation, and micro-fretting. This physical breakdown degrades the preload clamp force of the threaded joint, permitting the retaining nut to back off over time. If uncorrected, loose servo-control nuts can lead to excessive play, joint disconnection, and severe degradation or complete loss of main rotor pitch control during flight.
Repetitive 110-Hour Inspection Requirements
Under the final rule, maintenance engineers must accomplish an initial visual and torque inspection on each nut connecting the upper ball bearing end to all three main rotor servo-controls within specified flight hours. The FAA established a repetitive 110-hour inspection interval to verify that dynamic fretting does not cause progressive clamp loss before scheduled base maintenance checks occur.
The directive mandates specific non-destructive inspection methodologies depending on component history. Where technicians identify loose hardware or torque values below certified manufacturer thresholds, maintenance crews must perform detailed eddy current or fluorescent penetrant inspections to detect potential fatigue microcracking in the upper end fittings. If resistance, ratcheting, or mechanical hard points are encountered when rotating the ball bearing end into the servo-control fitting by hand, the affected components must be removed from service and replaced prior to further flight.
Maintenance Corrective Actions and Fleet Impacts
Where torque inspections reveal discrepancies or when scheduled replacement intervals mature, technicians must replace affected lock-washers with clean, unpainted hardware, apply certified locking wire, and apply specified protective sealing compound to prevent moisture ingress. Maintenance organizations are strictly required to report all inspection results, including zero-defect findings, to Airbus Helicopters within 30 days of completion to maintain global reliability tracking.
The FAA determined that the airworthiness risk posed by loose servo-control linkages is severe enough to prohibit the issuance of special flight permits under federal regulations, barring ferry flights with uninspected or discrepant assemblies. Across the United States civil helicopter fleet, the agency estimates the directive directly affects 48 rotorcraft. By standardizing strict torque inspection regimes and eliminating paint-induced clamping loss, the regulatory action safeguards rotorcraft flight control integrity across regional utility, offshore, and emergency medical service operations.
Sources
Spotted an error or have a tip? [email protected]




