Airbus Clarifies Stabiliser Jam Actions After Air France A321 Incident
Airbus has updated operational guidance for flight crews handling stabilizer jam warnings following a French investigation into an Air France A321 incident near Paris.
European airframer Airbus has issued clarified operational guidance to operators of the A320 family regarding horizontal stabilizer jam warnings following a formal incident investigation by French air accident investigators. The clarification stems from an investigation by France's Bureau d'Enquêtes et d'Analyses into an Air France Airbus A321-111 that experienced an anomalous stabilizer warning during its descent into Paris Charles de Gaulle Airport.
Investigators revealed that the warning occurred after manual pitch trim inputs drove the trimmable horizontal stabilizer to an extreme nose-down limit, forcing the aircraft's flight control computers to command near-maximum elevator deflection in response.
Initial Approach and Trim Disconnect
The event occurred aboard an Air France Airbus A321 flying scheduled passenger service AF1749 from Malaga, Spain, to Paris Charles de Gaulle with 196 passengers and six crew members on board. While descending through approximately 5,000 feet in moderate convective turbulence, the crew disengaged the autopilot to hand-fly the approach while retaining autothrust.
As the aircraft encountered varying vertical gusts, the pilot flying applied repeated manual nose-down pitch trim inputs using the mechanical trim wheels located on the center pedestal. Under Airbus normal flight control law, pitch trim is automatically maintained by the Elevator and Aileron Computers (ELACs). While manual trim inputs immediately override automatic trimming commands, flight data recordings showed that the pilot applied sustained manual nose-down wheel motion while simultaneously applying aft side-stick deflections to maintain the glidepath.
Computer Compensation and Jam Alert
The sustained manual inputs wound the trimmable horizontal stabilizer (THS) to negative 12.4 degrees, approaching its physical aerodynamic nose-down travel limit. To counteract the strong nose-down pitch moment and satisfy the crew's commanded pitch angle, the flight control computers automatically commanded the elevators to deflect upward by 27 degrees, near their maximum mechanical authority.
Because the elevators were held at near-full deflection without achieving trim alignment, the Electronic Centralized Aircraft Monitor (ECAM) detected an abnormal control position and triggered a master caution warning: F/CTL STABILIZER JAM.
The flight crew followed the ECAM stabilizer jam checklist, which requires stabilizing speed and preparing for landing without further automatic pitch trim assistance. Despite the advisory message, the stabilizer was not mechanically blocked; it was mechanically capable of movement but positioned at an extreme aerodynamic offset. The aircraft landed uneventfully on Runway 27R at Charles de Gaulle, and technicians found no mechanical defects in the pitch trim actuators or jackscrews.
Revised Operating Instructions
Following technical analysis by BEA and Airbus, the manufacturer determined that the wording of the existing abnormal procedure could lead flight crews to misdiagnose aerodynamic saturation as a physical control failure. Airbus has consequently issued an Operational Information Note clarifying how the flight control logic evaluates stabilizer trim status during manual handling in turbulent atmospheric conditions.
The guidance reminds operators that manual trim operation is rarely required in normal law and warns crews against opposing side-stick demands with manual trim wheel actuation. Additionally, flight crew training modules are being updated across A320 operators to reinforce proper monitoring of pitch trim position indicators on the primary flight display during turbulence penetration.
Sources
- bea.aero/en/investigation-reports/notified-events/detail/incident-to-the-airbus-a321-registered-f-gmzc-operated-by-air-france-on-27-04-2025-near-paris-charles-de-gaulle-ad/
- bea.aero/fileadmin/user_upload/BEA2025-0161_F-GMZC_RSE2_fr.pdf
- flightglobal.com/ops-safety/2026/11/airbus-clarifies-stabiliser-jam-procedure-after-pilot-manually-mis-trimmed-a321/
Spotted an error or have a tip? [email protected]




